Ozone Concentration 10~3000pphm,Size 100 to 1000L Ozone Test Chamber
Ozone chamber simulation and strengthening the atmosphere of ozone conditions, the study of the role of ozone on the rubber, rapid identification and evaluation of rubber anti-ozone aging performance and anti-ozone agent Protective effect of the method, and then take effective anti-aging measures to improve the life of rubber products.
Application
It is widely used in paint, resins, plastics, printing and packaging, aluminum, adhesives, auto, cosmetics, metals, electronics, electroplating, medicine, etc.
Technical Sheet
| Model |
MCY-125 |
MCY-512 |
MCY-1000 |
| Inner Size(W*H*D)cm |
50*50H*50 |
80*80H*80 |
100*100H*100 |
| Temperature Range |
0℃~110℃ |
| Temperature Flutuation |
0.5℃ |
| Temperature uniformity |
≤2℃ |
| Humidity Deviation |
3%RH |
| Ozone Concentration |
10-1000pphm(adjustable) |
| Ozone Concentration Deviation |
0.1pphm |
| Air Velocity for Ozone |
20L~80L/min |
| Inspection sensor |
Imported inspection sensor with strong anti-interference performance and at least 8-10 years of working life. |
Material:
(A) Inner box: SUS304 stainless steel plate
(B) Outer case: paint (beige) or SUS-304 stainless steel plate
(C) Insulation: rigid polyurethane foam + aluminum silicate insulation cotton double protection.
Doors:
(A) Open the door, turn left. window frame / door frame two silicone rubber seal and anti-condensation electric device.
(B) Doors and windows with observation window above W300xH450 mm, lighting
Shelf / Jig requirements (Only for dynamic testing):
(A) At both ends of the test specimen to be contacted with ozonized air, the test direction of the specimen shall be substantially parallel to the direction of the airflow
(B) The fixture should be made of a material that is not easily decomposable to ozone (eg aluminum).
(C) the sample rotation speed between (20 ~ 25) mm / s, in a vertical dry air flow in the plane, each sample at the same time to maintain a fixed rate of rise.
(D) The same specimen is rotated for a week (8 ~ 12) min. The scanning area of the specimen is at least 40% of the effective area of the ozone chamber.
(E) Specimen preparation shall comply with the requirements of GB / T 9865.1. The sample is best cut from the new mold out of the test piece, if necessary, can be cut from the finished product. Samples should be at least 3 samples per test condition. The length of the standard specimen is not less than 10mm, the thickness of 2.0 mm disabilities 0.2mm, the length of the specimen before the two ends of the specimen is not less than 40mm.
Control Panel:
(A) Controller display
(B) Power switch
(C) Fault alarm; Ozone Chambers
(D) Rotary governor
Ozone chamber configuration:
(A) With a stainless steel SUS # 304 rack turntable one
(B) φ50mm lead hole lead hole: 1, and with a hole cover and silicone rubber plug.
(C) 4 casters only for ozone chamber
(D) Horizontal fixed tripod 4 only
(E) There is a drain hole in the rear of the box to facilitate the condensate drain of the unit; (diameter 8%
(F) Three-phase five-wire system (four-core cable + protective grounding wire) One cable (2.5 meters long).
Product Tags:
|
|
Ozone Industrial Test Chamber Ozone Concentration 10~3000pphm Size 100-1000L Images
|
